Report: Jungheinrich Error Code 0802
| Diagnosis | Solution | |-----------|----------| | Pedal sensor voltage out of range | Replace complete accelerator pedal assembly (part varies by model; e.g., 52084703 for ETV 114). | | Corroded connector pins | Clean with DeoxIT D5, apply dielectric grease, and replace damaged pins using a Molex extraction tool. | | Chafed wiring harness | Repair with solder + heat shrink (do not use twist connectors). Replace entire pedal harness if multiple breaks exist. | | 5V reference shorted to ground | Trace and isolate the short. Remove the pedal connector; if 5V returns, the pedal is shorted internally. If still 0V, disconnect controller — if still 0V, harness short. | | Lost calibration | Perform manual calibration (above) or use J’Diagnose to reset pedal limits. | | Faulty main controller | Replace or repair controller (e.g., Jungheinrich parts #565903). Requires firmware reflashing. | jungheinrich error code 0802
If your truck displays code 0802, follow these diagnostic steps: Perform a System Reset: Turn the truck completely off and remove the key. Report: Jungheinrich Error Code 0802 | Diagnosis |
In the Jungheinrich diagnostic hierarchy, Error 0802 generally refers to a fault in the Steer Angle Sensor (or Steer Encoder) circuit. Sensor resistance out of range (< 50 ohms