Redsail Cutting Plotter Software Installation Now
Installing your Redsail cutting plotter software correctly is the foundation for precise vinyl cutting and professional signage. Whether you are using a legacy model or a brand-new machine, the setup process generally involves two main components: the USB driver and the cutting software (typically Artcut, WinPCSIGN, or a CorelDRAW plug-in).
PC Compatibility: Ensure your Windows version (7, 8, 10, or 11) matches the driver architecture (32-bit or 64-bit). 2. Step 1: Install the USB Driver redsail cutting plotter software installation
Setting up your Redsail cutting plotter involves a two-step installation process: first installing the hardware drivers to ensure your computer recognizes the machine, and then configuring your chosen design software to communicate with it. 1. Install Hardware Drivers In Device Manager, under Ports (COM & LPT)
If you’ve followed this guide to the letter and still encounter failure, capture a screenshot of your Device Manager (with COM ports expanded) and email Redsail official support. Most likely, a simple firmware update or port reassignment will solve the case. Step 6: Send a Test Cut
Post-Installation Steps
Part 2: Installing the USB Driver (The Critical Step)
If you have a driver CD that came with the machine, try that first. If you do not have a CD or it fails, follow this method. RedSail cutters often use a generic USB-to-Serial chip (usually HL-340 or CH340).
"Maybe it needs admin privileges," Marco suggested, leaning over her shoulder.
- In Device Manager, under Ports (COM & LPT), right-click your Redsail COM port.
- Properties → Port Settings → Advanced.
- Change “COM Port Number” to COM1, COM2, COM3, or COM4 (avoid COM9+ as older cutting software struggles).
- Set Bits per second: 9600 or 115200 (check your plotter’s LCD menu: Baud Rate).
- Data bits: 8, Parity: None, Stop bits: 1, Flow control: None.
Step 6: Send a Test Cut
- Draw a simple square or circle in the software.
- Load a small piece of vinyl into the plotter.
- Click Cut or Output.
- The plotter should move and cut the shape.