Stevens Model 94 Parts Diagram New Portable File

The Stevens Model 94 is a classic break-action, single-shot shotgun produced by the Stevens division of Savage Arms from 1937 to 1984. Renowned for its utilitarian design and "rebounding hammer" safety feature, it remains a popular choice for restoration and general-purpose shooting. Identifying specific parts for this firearm requires understanding its various sub-models (e.g., 94A, 94B, 94C, 94H) and their slight mechanical evolutions over nearly 50 years. Understanding the Stevens Model 94 Assembly

If you are looking at a parts diagram because your Stevens 94 isn't working, check these common culprits: stevens model 94 parts diagram new

Cross-Compatibility: Remember that many parts for the Stevens 94 are interchangeable with the Savage 219 or the Sears Ranger equivalent models. Always verify the specific series (e.g., 94 Series A vs. Series M) before purchasing. Safety Note on Restoration The Stevens Model 94 is a classic break-action,

Barrel: The barrel is the metal tube that the bullet exits when fired.
Receiver: The receiver is the main frame of the rifle that houses the action.
Lever: The lever is the long, pivoting arm that is used to eject spent cartridges and chamber new rounds.
Action: The action is the mechanism that loads, fires, and ejects cartridges.
Stock: The stock is the wooden or metal frame that supports the rifle and provides a comfortable grip for the shooter.
Buttplate: The buttplate is the metal plate that covers the end of the stock.
Fore-end: The fore-end is the wooden or metal piece that supports the barrel.
Trigger: The trigger is the lever that is pulled to fire the rifle.
Hammer: The hammer is the spring-loaded piece that strikes the firing pin.
Firing Pin: The firing pin is the small metal pin that ignites the cartridge.

Receiver screws
Action screws
Lever pivot pin
Lever spring

Group 3: The Lockwork (Trigger Plate Assembly) – The most critical section

Trigger Plate (Part #10): The removable floorplate of the receiver.
Trigger (Part #11) & Trigger Spring (Part #12): Simple leaf-spring design.
Hammer (Part #13): External spur hammer. The mainspring is often inside the hammer shank.
Hammer Mainspring (Part #14): A coil spring. If the gun feels “weak” on firing, this is the culprit.
Sear (Part #15): Engages the hammer notch. A worn sear leads to a dangerous “follow-through” (gun fires when closing).
Sear Spring (Part #16): Often a tiny wire spring.
Safety (Part #17): A button or slide safety on the tang (rear of receiver).
Firing Pin (Part #18): A hardened pin struck by the hammer. Most commonly broken part on the Model 94.
Firing Pin Retainer (Part #19): A small screw or pin holding the firing pin in place.