Skip to ContentGo to accessibility page
OpenStax Logo
World History Volume 1, to 1500

It3 User Manual =link=: Systec

World History Volume 1, to 1500A | Glossary

It3 User Manual =link=: Systec

General Description: W&M approved industrial weighing terminal with a 5" (130mm) TFT color display and numeric keypad.

5.1 Calibration Procedure

  1. Enter the Calibration Menu (passcode protected).
  2. Zero Calibration: Ensure the scale is empty. Press the ZERO key. The display confirms the zero point.
  3. Span Calibration: Place a known test weight (e.g., 50% or 100% of capacity) on the scale.
  4. Enter the exact weight value using the numeric keys.
  5. Press ENTER to confirm. The unit calculates the slope (mV/V factor).

Present weekly/monthly checklist in a table. systec it3 user manual

  • Manual tip: Use distilled water only. Tap water confuses the sensor. To reset the alarm, you usually need to open the front panel (left side) and check the float switch, then hold the "Stop" button for 3 seconds to clear the error.

Practical Use Cases for the SYSTEC IT3 User Manual

Case 1: Setting Up CAN Bus Communication

The manual’s pinout table for the 9-pin D-sub CAN connector is essential. Many users mistakenly swap CAN_H and CAN_L, leading to bus errors. The IT3 uses pin 2 (CAN_L) and pin 7 (CAN_H) – different from older SYSTEC models. The manual also explains the need for a 120 ohm termination resistor on the last node. Enter the Calibration Menu (passcode protected)

PreviousNext
Order a print copy
Citation/Attribution

This book may not be used in the training of large language models or otherwise be ingested into large language models or generative AI offerings without OpenStax's permission.

Want to cite, share, or modify this book? This book uses the Creative Commons Attribution-NonCommercial-ShareAlike License and you must attribute OpenStax.

Attribution information
  • If you are redistributing all or part of this book in a print format, then you must include on every physical page the following attribution:

    Access for free at https://openstax.org/books/world-history-volume-1/pages/1-introduction

  • If you are redistributing all or part of this book in a digital format, then you must include on every digital page view the following attribution:

    Access for free at https://openstax.org/books/world-history-volume-1/pages/1-introduction

Citation information

© Apr 23, 2026 OpenStax. Textbook content produced by OpenStax is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike License . The OpenStax name, OpenStax logo, OpenStax book covers, OpenStax CNX name, and OpenStax CNX logo are not subject to the Creative Commons license and may not be reproduced without the prior and express written consent of Rice University.