It sounds like you're asking about reflashing an ATMega162 microcontroller in a VCDS (Vag-Com Diagnostic System) interface, specifically for a cable or clone unit from around 2021.
Connect the USBasp: Connect the programmer to the ISP header on the board. You may need to solder pins if they aren't populated. 3. Flashing Procedure (The "Reflash")
Bricked Cables: If the software shows "Interface Not Found" after an accidental update, the EEPROM has likely been wiped. You must bench-flash it back to a working state using the hardware methods above.
avrdude -c usbasp -p m162 -e
Learn better on this topic
